🟧 Previous Chapter
🟧 Next Chapter
Goal: Model Rectangle Jar Tip
![Untitled](https://s3-us-west-2.amazonaws.com/secure.notion-static.com/e3c97a1a-937c-495f-b597-b8c5bedac51f/Untitled.png)
This is what we are starting with ⬇️
![Untitled](https://s3-us-west-2.amazonaws.com/secure.notion-static.com/7173f4df-9813-49f6-8468-52d537e43b89/Untitled.png)
1. Loop Cut
![Untitled](https://s3-us-west-2.amazonaws.com/secure.notion-static.com/30600906-e8db-47c9-947d-31e17ffcab6e/Untitled.png)
- Press 2 to switch edge selection mode ⬆️
![Untitled](https://s3-us-west-2.amazonaws.com/secure.notion-static.com/6e5b1766-bd67-43e7-a371-28aacfaa94b7/Untitled.png)
- Ctrl + R = Loop Cut Mode ⬆️
- Find the center of the edge ⬆️
![Untitled](https://s3-us-west-2.amazonaws.com/secure.notion-static.com/82818c91-8db8-41b8-8fe2-58e523a903ca/Untitled.png)
- Click to enter loop cut mode ⬆️
- Slide down ⬆️
![Untitled](https://s3-us-west-2.amazonaws.com/secure.notion-static.com/f977df48-4152-4a43-bc74-a667ab75c80c/Untitled.png)
- Click to confirm the position of the edge loop ⬆️
2. Extrude Along Normals